Felt squeegee for wrapping foil | Scratch-free application with a soft felt edge

The squeegee determines whether your wrapping foil lies flat or ends up full of air bubbles. With the VNSTRA® felt squeegee, you apply the wrapping foil evenly and push the air towards the edges without damaging the design.

The difference lies in the felt edge. A bare plastic squeegee slides harshly over the wrapping foil and leaves visible scratches on high-gloss and fine wood-grain finishes, especially where the light hits it. The soft felt side distributes the pressure and glides along, keeping the surface flawless.

Work from the center outwards, in overlapping strokes of about a handbreadth. Hold the squeegee at a slight angle and apply firm but not excessive pressure. This allows the air to escape through the air channels in the wrapping foil towards the edge, instead of trapping it in a bubble.

For corners, edges, and contours, a little heat helps. Briefly heat the wrapping foil with a hairdryer, pull it slightly taut, and then press it into the contour with the squeegee. Let the entire piece cool down before trimming.

Keep the felt clean: a single grain of dust under the edge is enough to leave a streak. Wipe the edge regularly and replace the squeegee as soon as the felt becomes flat or frayed.

This squeegee works with all interior wrapping foils in our range. You will also find a video tutorial on the product page of each wrapping foil, showing you step by step how to use it.